Forum
.disconnect() function does not exist?
First post and replies | Last post by SOLO_Francesco, 3 weeks ago
-
By jlobin 4 weeks ago
-
By SOLO_Fran... 3 weeks ago
-
By jlobin 3 weeks ago
-
By SOLO_Fran... 3 weeks ago
- view all posts
SoloPy - ERROR - serial_open: Exception during the serial inizialisation
First post and replies | Last post by Simon, 3 months ago
How do you switch between Speed and Position mode while the motor controller is running?
First post and replies | Last post by baymax, 5 months ago
-
By baymax 5 months ago
-
By SOLO Team 5 months ago
-
By SOLO Team 5 months ago
-
By baymax 5 months ago
- view all posts
Ensure Torque/Speed/Position command is executed by Solo Mini v2
First post and replies | Last post by baymax, 6 months ago
-
By baymax 6 months ago
-
By baymax 6 months ago
-
By SOLO_Fran... 6 months ago
-
By baymax 6 months ago
- view all posts
Correct way to stop a motor in TORQUE, SPEED and POSITION mode
First post and replies | Last post by baymax, 6 months ago
-
By baymax 7 months ago
-
By SOLO_Fran... 6 months ago
-
By baymax 6 months ago
SOLO microPython library - ESP32*
First post and replies | Last post by SOLO_Francesco, 7 months ago
Serial_open error during UART control from Raspberry Pi
First post and replies | Last post by mrcube3, 10 months ago
-
By mrcube3 10 months ago
-
By SOLO_Fran... 10 months ago
-
By mrcube3 10 months ago
-
By mrcube3 10 months ago
- view all posts
E2 Light Remains off on two SoloV2 boards
First post and replies | Last post by SOLO Team, 1 year ago
-
By ethpaige 1 year ago
-
By SOLO Team 1 year ago
-
By ethpaige 1 year ago
-
By SOLO Team 1 year ago
- view all posts