FORUM
Notifications
Clear all
Topic starter
I want to drive my new BLDC motor using SOLO Uno V2, and it has a hall sensor board.
It is small and has limited cooling, so I want to optimize energy efficiency using reluctance torque.
So, I want to know whether it support Id or advance angle control even the terminal voltage is not saturated(e.g., MTPA control method)?
If so, could you tell me how can I configure this?
Regards.
Posted : 25/08/2025 9:27 am
Hello @ahn,
At this point we only support Field weakening, and the MTPA is not covered yet.
Milad
If you found the answers helpful and you could solve your problems, please kindly verify here to help others in the future.
Posted : 26/08/2025 7:57 am
